1UP!

"Brickman" (legomaniacman) 10/12/2019 at 19:46 • Filed to: None

8

4

Put a 1" shock spacers on the ZR2.

before

after

spacer is wayyyy up there. Wish I had my 18mm ratchet wrench on me. Standard wrench did fine, just took about 30 minutes to undo 3 nuts.

!!! UNKNOWN CONTENT TYPE !!!

Drives the same, but an inch higher in the front. Helps level it even to the rear suspension. Inch is the most you can do without hurting the C/V joints.

That front bumper has to go...

That’s why I ordered this!!!! CBI offroad ZR2 front bumper with bar. Went with this one over the Relentless because this one has a gasket that goes on top between the body , and they make more stuff so better build quality?

Im not adding a winch, but will add two square yellow lights to use as fog lights / blind everyone (no I don’t do that)

Should be in sometime in January

Maybe some bigger tires when these need replacing ;D

HFV has no HFV. But somehow has 2 motorcycles > Brickman 10/12/2019 at 22:02

0

Won’t the weight of that bumper eat up the 1” lift? 

Brickman > HFV has no HFV. But somehow has 2 motorcycles 10/12/2019 at 22:27

1

I don’t think it will. I tried hanging off the radiator support and the truck doesn’t go down. I weigh about 270, bumper is only 150lbs.

adamftw > Brickman 10/14/2019 at 06:45

1

That CBI bumper is rad.

Gone > Brickman 11/11/2019 at 09:23

1

Be curious how the install goes on the bumper. I just picked up a ‘19 ZR2  Satur da y and the CBI bumper is high on the list (aluminum though ).